null
Reasons Why Reasons Why
EarthQuaker Devices Gary Automatic Pulse Width Modulation Fuzz and Dynamic Natural Overdrive

EarthQuaker Devices Gary Automatic Pulse Width Modulation Fuzz and Dynamic Natural Overdrive

$199.00
SKU:
372815
UPC:
810019914478
Weight:
0.00 LBS
Shipping:
Free Shipping

Videos Hide Videos Show Videos

Financing

Pictures Are Stock Photos!

 

Do you want more photos? We are happy to provide them. Just let us know what you need.

Gary Automatic Pulse Width Modulation Fuzz and Dynamic Natural Overdrive

EarthQuaker Devices is proud to introduce you to your new best bud, Gary. This little big guy was dreamt up by the one and only Lee Kiernan from the crushing and most necessary band IDLES!

Gary started as a simple request to create a compact version of the now discontinued Gray Channel®, which was a mainstay on Lee’s board and a big part of his main drive tone. This was all fine and good, and sounded quite sick, but Gary was demanding that we look deeper and explore his dark side a little more, Gary after dark, Saturday night Gary. So, we sat him down and began the trek of figuring out old Gare-Bear once and for all. The result is a dynamic and destructive pulse width modulated fuzz paired with a natural-sounding op-amp overdrive.

Specification

Dimensions: 4.75 x 2.50 x 2.25 in. (121 x 64 x 57 mm) with knobs

Current Draw: 20 mA

Fuzz:

Input Impedance: 1 MΩ

Output Impedance: <1 kΩ

Overdrive:

Input Impedance: 500 kΩ

Output Impedance: <1 kΩ

TRS expression pedal wiring:

Tip: Wiper

Ring: +3.3V

Sleeve: Ground

Flexi-Switch® Technology: This device features Flexi-Switch® Technology! This relay-based, true bypass switching style allows you to simultaneously use momentary and latching style switching.

For standard latching operation: tap the footswitch once to activate the effect and then tap again to bypass.

For momentary operation: hold the footswitch down for as long as you’d like to use the effect. Once you release the switch the effect will be bypassed.

Since the switching is relay based, it requires power to pass signal.

Power: This device takes a standard 9 volt DC power supply with a 2.1mm negative center barrel. We always recommend pedal-specific, transformer-isolated wall-wart power supplies or multiple isolated-output supplies. Pedals will make extra noise if there is ripple or unclean power. Switching-type power supplies, daisy chains and non-pedal specific power supplies do not filter dirty power as well and let through unwanted noise. DO NOT RUN AT HIGHER VOLTAGES!

Artwork: Artwork by Charlotte Gosch,

 

Learn More